back to board Main Page
Not enough heat
From the WFO board
Posted by Rado (144.134.145.153) on September 15, 2004 at 08:19:23:
In Reply to: Not enough heat posted by Richard Stybak on September 15, 2004 at 00:50:35:
Hmmm? I had a thought about how to change the blanket layer involving lifting of the heavy dome, taking of the insulation applying layer of same castable onto the stainless filling the space and placing it back again. I know heavy! Several 5mm holes would have to be drilled into the steel permitting air getting out. Or could you keep holding it up in the current place and dropping the floor down?
- Not enough heat - Rado
- Not enough heat - WILLIAM HICKS
- Not enough heat - Richard Stybak
- Not enough heat - Rado
- Not enough heat - Richard Stybak
- Not enough heat - Richard Stybak
- Not enough heat - Rado
Jamie and Katrina's brick oven with temperature gauge, in Victoria.-
Concrete blocks used for the oven’s outer walls. By Joe in Connecticut USA -
Wood fired family oven and chimney project by Robert in Austria -
My oven with fireplace, cook food and heat water, by Joel in Philippines -
Baking sourdough breads in quantity in Canada -
Pizza oven and hut built by Tony in Philippines
